The Multi-Functional Storage Unit, also known as an MFSU, is a Tier 3 (Ultimate) energy storage device. It is able to store up to 10,000,000, or 10 million EU (making it capable of powering multiple teleportations, running a Mass Fabricator, or directly storing power from some Nuclear Reactors), and can accept a maximum packet size of 512 EU from each of the 5 input faces (bigger EU packages cause the MFSU to explode). It will accept a max of 4096 EU/t. (For example, you can have 10 MFSU's outputting in one MFSU, resulting in a total input of 5120 EU/t, it will recive only 4096EU/t, but because there are 10 packets of 512 EU, the MFSU won't explode).
A charged MFSU produces a high voltage current of 512 EU/t from its output face. To use power from a charged MFSU on machines with lower power requirements, you must provide power through transformers to reduce the rate of flow so as not to explode your machine by overpowering it. For example: To power a standard machine such as an induction furnace from a charged MFSU, you would connect from the MFSU to a MV Transformer , however, if you require to power a lower tier machine, such as an electric furnace, you must place a LV Transformer following the MV Transformer, or else it will result in an explosion.
Alternatively, Transformer Upgrades can be applied to low tier machines to allow them to use higher levels of power, eliminating the need to step down through a separate transformer first.
The MFSU will not explode when it reaches storage capacity.
Like all storage units, its output face is marked by a special texture, which usually faces the player when the block is placed. The direction of the output face can be changed by right-clicking with a Wrench onto any of the input faces of the block. Normally, this will point the output face towards the player, but holding Shift while right-clicking will point the output face in the opposite direction.
Note: The MFSU can be dismantled with a wrench. It does not have to be in lossless mode. This has been tested multiple times.
Note that once dismantled, the MFS Unit will lose any power it had been storing, so be sure to move the stored energy into other storage devices before dismantling.
Like other storage units, The MFS Unit has 6 Redstone Behavior settings. and those are:
|Behavior||What will happen|
|Emit if full||Emits a Redstone signal on all sides when full.|
|Emit if partially filled||Emits a Redstone signal on all sides when the stored EU is between 0 and 10 Million EU.|
|Emit if empty||Emits a redstone signal on all sides when the stored EU is 0.|
|Do not output energy||When a Redstone current is supplied, it will NOT output any EU.|
|Do not output energy unless full||When a Redstone signal is received, it will not output any EU until the charge level is at maximum.|
|Nothing (Default on placement)||
The MFS Unit will not react to any kind of Redstone current.
Warning: If the MFSU is placed directly adjacent to a bare nuclear reactor or a nuclear reactor chamber connected to a reactor, the MFSU can explode from the energy output of a reactor. This goes as well for the HV-transformer.
To get this to work with basic machines, put an MV Transformer then an LV Transformer out of its output face, IT MUST BE IN THAT ORDER, or place two transformer upgrades in every machine BEFORE CONNECTING. Connect it to the machines using Glass Fibre Cables or HV Cables.
There is a glitch when you completely fill up a MFSU and cut the power, any machines that should drain power still get powered but the MFSU doesn't lose power. This can be fixed by relogging.
|Raw Materials Needed|
|38||File:Grid Lapis Lazuli.png||Lapis Lazuli|
|Input||Up to 512 EU/t|